Peugeot 308 Key Fob Problems and How to Fix Them
If your Peugeot 308 key fob has stopped working for a while it could be due to a dead coin battery or water damage, receiver module issues or a faulty electronic chip. Fortunately, these issues are easy to fix and you'll get your car back to normal in no time at all!
Car keys can also be damaged due to the blade getting worn. You can solve this issue by visiting your local Car Key Man Auto Locksmith to get a new blade installed.
Battery
The key fob in your Peugeot 308 may die or become weak enough to not send a clear signal. The key fob could stop working and prevent you from locking or unlocking your doors, or starting the engine. You'll need a replacement battery for your key fob to correct this.
You can buy a brand new battery at an auto parts store, or at your local hardware store. When you purchase the battery ensure that it's fresh and hasn't just been sitting on the shelf for a long time. A brand new battery will have greater capacity and can send a stronger signal the car.
After replacing the battery, try unlocking the doors and locking them using the key fob. If peugeot 3008 key fob aren't unlocking it's possible that the receiver module inside the car is at fault. Your local Peugeot dealer can reprogramme the receiver module.
It's also possible that the key fob's internal chip is damaged. You can harm your key fob if you drop it on the ground, or expose it to water. Rubber seals that protect your chip from moisture may get worn out over time. This is particularly true if you expose your key fob to water over long periods of time, for example, swimming it in the ocean. To prevent this from happening, it's important to keep your key fob safe from moisture and to never let it come into contact with water.
Water Damage
Don't give up on your key fob when it becomes wet, whether you dropped in an aquisition or stumbled into a Puddle. The key fob is protected by rubber seals, but prolonged exposure to water may harm its electronic chip. Water is a great conductor, and any water that enters the key fob could cause a series short circuits which eventually damage the electronic chip. After removing the batteries, clean the contact surfaces with isopropyl and then dry them completely before putting them back into.
Your Peugeot 308 may not start because of a dead battery. Jumper cables can be a great method of restarting the engine when you have an extra car. If the battery is damaged, it must be replaced.
A bad receiver in the car could also block it from receiving the signal from the key fob. It could be a issue with the antenna, or wiring, or the key fob could be damaged. If you have an entirely new key fob, it might need to be programmed to the vehicle. If you are unable to solve the issue yourself seek out a professional technician. A trained technician will be able find the issue quickly and fix it immediately.
Radio Interference
The signs of a key fob not being recognized or having a restricted range usually indicate that there is a problem in the system. It could be radiated or conducted, with the latter being caused by power supply cables or speakers wiring that are too close to electrical components. In general, rerouting cables and moving them away from these components can solve the issue.
It's unlikely that anyone is listening in on the signals from your key fob to steal your car, but it's possible that the signal has been drowned out by radio frequency interference. This is a straightforward issue to solve.
If you're experiencing a problem with your key fobs that aren't recognized, try a new battery. Make sure that the battery is of the correct size and type. Batteries that are not the right size can cause damage to your device.
These devices may interfere with the key signal if they use the same radio frequency. It is advised to avoid using these devices with your key fob.
Pairing Issues
A car's remote keyless entry system is a receiver that receives radio frequency signals from the key fob. You won't be able to start your vehicle if the receiver is not functioning properly even if your key fob is functioning and can be reprogrammed. The issue can be caused in a number of ways, including by a dead coin-cell battery or water damage. The receiver could also be malfunctioning due to a software glitch or internal damage in the key.
The battery inside your Peugeot 308 keyfob may have failed. It is possible to replace it with a brand new battery but it's essential to choose the right battery for your key fob. The wrong battery could cause further issues with the key fob, therefore it is best to choose the original or an alternative that is similar in size, voltage and specification.
Another reason the reason your Peugeot 308 key fob might not be working is due to the fact that it is linked to another vehicle. It is possible that you have accidentally given your key fob a friend or the key was used to unlock other vehicles. You can fix this by reprogramming your key fob using an OBDII scanner. This tool will ask for information about your vehicle, for example, its VIN or engine type. It is essential to enter the correct details.